Archive | April, 2012

How To Install Drip Irrigation In A Raised Bed / Woolly Pocket Meadow

how to1 How to Install Drip Irrigation in a Raised Bed / Woolly Pocket MeadowMaterials needed:

Cost estimate:
$60-100.
Note: This will leave you with extra supplies (drip tubing, supply line, etc) that you can use for other drip projects in your yard. So make sure to buy a bunch of fittings! I keep my extra fittings in a little plastic part box.

Time estimate:
If this is your first time working with drip irrigation allow 60-90 minutes to install a system of this size. As you get more used to working with drip supplies it will go quicker.

Steps:

1. Decide you the layout of your irrigation. If you have emitters every 6″ you will want to space the lines 6″ apart so there is even water coverage over all the soil. Set up your raised beds and fill with soil. In this case I used (4) Woolly Pocket Lil’ Meadows.

2. Insert stakes into soil every foot or so where you plan to run drip line. Starting at one end of bed snap drip line into stakes and continue across bed snapping the drip line into the  stakes. At end of line cut tube with scissors. Repeat for each row. Push End Plugs (Goof Plugs) into the end of the drip line furthest away from the water source.

3./4. Once all the drip lines are in place you will need to connect them with drip supply line (tube with no emitters). Use “T’s” & “L’s”. The fittings will be somewhat difficult to push into the drip line as it needs to be very snug. I like to use the tip of a stake to stretch out the opening of the tube so that the fitting slides in easier. Another trick is to heat the end of the tube with a lighter to temporarily soften the plastic.

5. Run a longer section of drip supply line (no emitters) to your water source. For a simple connection to a spigot (that you will manually turn on) attach a 3/4″ Female Pipe Thread (FNPT) Adapter with Washer x 1/4″ Compression to the supply line and screw on to spigot. Super easy.  If you want to add an Irrigation Controller/Timer, mount it to the spigot. Add a pressure regulator (if it isn’t already built into the timer) and then connect the 3/4 Female Pipe thread. Also pretty easy.

6. Test the irrigation. Let it run for 20+ minutes and observe the moisture pattern. Confirm that all the fittings are snug and that water is being delivered where you need it. Adjust location of stakes as needed. Once everything is working properly you can get busy planting!

I installed these raised beds in August 2011 and planted them with fall starts from Sunset Nursery in Silver Lake. In the photo below we have lettuce, onions, chives, parsley, cauliflower, rhubarb, carrots, cucumber and a couple of pepper plants.

10 days after planting:

after planting How to Install Drip Irrigation in a Raised Bed / Woolly Pocket Meadow

6 weeks after planting –the fall garden really thrived with drip irrigation.

final garden How to Install Drip Irrigation in a Raised Bed / Woolly Pocket Meadow

 

 

 

 

 

 

Comments { 1 } · April 30, 2012

Starting Seeds Indoors – My Grow Light Setup

Last December I went a little crazy buying (72) kinds of heirloom seeds from Baker Creek Heirloom Seeds. That coupled with the fact that we are greatly expanding our test garden this year, got me thinking about getting a jump start on the season with grow lights.

So far I have done about three rounds of starting plants from seeds in my indoor  “greenhouse” and I have been thrilled with the results! Here is how I did it:

GEAR
Hydrafarm JSV 4-Foot Jump Start T5 Grow Light System
Note: I bought the 4′ long version but they also have a 2′ foot version if you are tight on space.
Hydrafarm Seedling Heat Mat
This should be purchased to match the size of your grow light. I got the 4′ heat mat.
Hydrafarm MTPRTC Digital Thermostat For Heat Mats – This is a regulator that controls the temperature on the heat mat.

Note: You can get all 3 on Amazon for about $110 (PLUS they are eligible for Prime shipping).

IMG 3685 Starting seeds indoors   My grow light setup

LOCATION
I decided to set up the grow light (and gear) in the second story of my office (my office is a  guest house in my backyard). The location that was out of the way (so the light didn’t bother me)  but close enough for me to check on the plants daily. A garage or basement would also work well. I have tried using a smaller grow light in my shed, but as the shed was not climate controlled it seemed to get too hot for the plants.

INSTALL
The light (and frame) arrived in a pretty small box and snapped together in less than 5 minutes. I saved the box so that I could use it to store the light in frame when I am not using it.

HEAT MAT
The heat mat (black with green writing above) came rolled up. I need to pile books on it overnight to get it flattened out. The striped towel is there only there because the table is glass and I wanted to insulate the heat mat.

HEAT REGULATOR
You can’t see it in the photo but the heat regulator is on the floor near the power strip. It has a cord with a probe on it that you stick into the soil of one of the plant pots so that it can read the temperature of the soil. Different seedling prefer different temperatures. The mat comes with a heat chart printed on it. I kept mine mostly set to the mid 70′s.

TIMER
I hooked up the light to a timer on my Smarthome automation system so that it could automatically turn on and off, giving the plants 18 hours of light. You can buy a cheap timer at a hardware store or online that would do the same thing. My light was set to turn on at 7am and shuts off at 11 pm.

IMG 3726 Starting seeds indoors   My grow light setup

SOIL
You can use any potting soil to start seeds, but If you really want to do it right they make special soil for starting seedlings. I bought some soil online (I don’t think it was this brand – but similar) and when I needed more I bought more at my local nursery.

POTS
I started the veggie seeds in recycled plastic pots, labeling them all with popsicle sticks (also bought on Amazon) and a Sharpie marker.

SEEDS
Generally you place the seed in the soil to a depth equivalent to the seeds width. So if it is really small like a poppy seeds you just sprinkle it on top of soil.  A bigger seed like a pumpkin would get tucked down in soil deeper.

I put about twice as many seeds as I thought I would personally need in each container so that I would have some seedlings to give away to friends and neighbors.

TRAYS
Note the plastic trays under the pots, they are important to containing the water, keeping things tidy and allowing you to easy move seedlings around. I bought (4) of them on Amazon and then realized I need more so I bought another (4) at Home Depot. You should be able to find them at any decent nursery.

IMG 3738 Starting seeds indoors   My grow light setup

WATER
I found that I needed to water the seedlings about every 36 hours (1 -1/2 days). Some times I went 2 days but they seemed a little withered. Once the plants were more established and had roots that went all the way to the bottom of the container I could pour water into the tray (maybe a 1/4 or 1/2″) to allow it to go a bit longer between waterings.

IMG 3748 Starting seeds indoors   My grow light setup

This was taken about 8 days after I started the seedlings. The King Nasturtiums (in foreground) were the fastest growers and were fun to watch. They were also the first to leave the nursery.

IMG 3755 Starting seeds indoors   My grow light setup

TRANSPLANTING
This photo shows the plants about 10 days. I started transplanting some of the tomatoes into individual decomposable pots (at right) once the seedlings were big enough to handle. You can get these post at the nursery they come in a few sizes. I found the bigger ones are the best, in that they buy you more time to let the plant grow before it gets planted in it’s final location.
If you want you could start individual seeds in pots like this, but I found it to be more space efficient to start seeds in bigger pots and then separate them as they got larger (if needed).

ADJUSTING THE LIGHT
The light can easily be adjusted up and down. You probably should keep it adjusted to be a few inches above the plant. In this photo I had pulled the light up because I was working with the plants.

IMG 3837 Starting seeds indoors   My grow light setup

Day 15. Poets Flowers and Chinese Lanterns are growing pretty quickly.

IMG 3830 Starting seeds indoors   My grow light setup
Day 18. Tomatillos really thriving.

 Starting seeds indoors   My grow light setup

ADDED LED GROW LIGHT
Once I started the second batch of seedlings I needed to extend my work area, as I wanted to keep some of the round 1 seedlings under the grow lights until it warmed up outside more. I added an LED grow light (with pink-purple color) to the right of the T5 light.

Grow UFO LED Grow Light - from Sunshine Solutions

The LED is neat in that it cool, uses less energy and creates light in wave lengths that the plants can process, so it is more efficient. But this efficiency comes with a bigger price tag – almost $300. I probably wouldn’t recommend it for someone just getting started. I think these are usually used by growers who daisy chain them together in more commercial applications. But I wanted to try it out in my test garden. I haven’t done any real scientific tests between the lights but the plants seem to thrive under both lights.

IMG 3824 Starting seeds indoors   My grow light setupDay 21 – Transplanted tomatoes.

IMG 3806 1 Starting seeds indoors   My grow light setupPlants under LED grow light in foreground.

DURATION UNDER LIGHTS
I kept seedlings under lights for anywhere between 2 weeks – 5 weeks before I took them outside to plant them in the garden. I will note that the tomatoes I took outside earlier are healthier and much much bigger now than the tomatoes I kept under grow lights longer. So keeping them inside longer is not always a better idea.

ACCLIMATION
Eventually I started moving plants outside as the weather warmed up (mid-March – early April). I put the plants in semi-sun for several days to allow them to acclimate to outdoor weather. They didn’t have their cozy heat mat under them anymore!

Also – Some of them started getting eaten by bugs and caterpillars once they went outside so I tried to keep an eye on them. They had had no bug predators when they were inside.

PLANTING
I planted the seedlings in raised beds and pots, with drip irrigation. I placed them close together with a modified square foot layout.  It is still pretty early in the season (April 27th). But the garden is already booming and producing vegetables and herbs.

photo Starting seeds indoors   My grow light setup


If you have any questions about the grow lights or my setup please leave a comment below.
+ I’ll do a separate post on how I set up the drip irrigation in the raised beds soon.

Comments { 1 } · April 27, 2012

Uruguay: Punta Del Este

Comments { 0 } · April 24, 2012

Uruguay: Locks Fountain, Montevideo

While exploring Montevideo we came across Locks Fountain.  The tradition is that lovers attach a lock to the fountain with their names on it and then throw away the key, cementing their affections. We looked all over for a padlock– but unfortunately no one nearby was selling any.

The fountain itself was not that exciting, but I love the idea. It would be great to design a lock fountain where people had to climb into the water to attach the lock to some kind of structure.

IMG 3606 Uruguay: Locks Fountain, Montevideo

IMG 3609 Uruguay: Locks Fountain, Montevideo

IMG 3584 Uruguay: Locks Fountain, Montevideo

IMG 35741 Uruguay: Locks Fountain, Montevideo

IMG 35721 Uruguay: Locks Fountain, Montevideo

Plus — this little water feature is tucked around the corner from Lock Fountain. I love how it is built right into the sidewalk. And how the rocks are the same color as the sidewalk.

IMG 8142 Uruguay: Locks Fountain, Montevideo

Comments { 1 } · April 24, 2012

Patagonia: The End Of The Word – Ushuaia

Ushuaia is the most southern city in South America (and the world). Most travelers going to Antarctica pass through Ushuaia. We stopped for a couple of days to see penguins and go trekking.

 

 

Comments { 1 } · April 24, 2012